Description
When the control power was turned ON, an ASF board setting error was detected.
Subcode description
The ASF01 board operated abnormally when control power was turned ON.
Causes and remedies
| Cause | Remedy |
|---|---|
| Software (incorrect setting) | Check the following settings. [ASF01 board with RSW="0" not found] • Rotary switch setting on the ASF01 board (0) |
| ASF01 board (abnormal) | 1. Turn the power off and back on. 2. If the alarm recurs, replace the ASF01 board. Save CMOS.BIN before replacing the board. |
| SDCA01 board (abnormal) | 1. Turn the power off and back on. 2. If the alarm recurs, check that the SDCA01 board is connected and fully inserted. Save CMOS.BIN before replacing the board. |
| ACP01 board (abnormal) | 1. Turn the power off and back on. 2. If the alarm recurs, replace the ACP01 board. Save CMOS.BIN before replacing the board. After replacing the ACP01 board, remove the SD card from the original ACP01 board and insert it into the new ACP01 board. |
| Other | If the alarm occurs again after implementing the countermeasures, contact our service department and describe the circumstances when CMOS.BIN was saved (operating procedure, etc.). |