[Cause]
Spot program position correction is executed in diagnostic mode instead of normal spot welding motion.
[Countermeasure]
This is an informational message. No countermeasure is required. To execute spot program position correction in correction mode, disable diagnostic mode on the spot program position correction settings screen as follows. 1. If TP is disabled, set the execution mode in AUTO mode to Correction. 2. If TP is enabled, set the execution mode in teach mode to Correction. To execute normal spot welding instructions, disable spot program position correction. 1. If TP is disabled, turn the spot program position correction enable signal OFF. 2. If TP is enabled, disable spot program position correction on the test execution screen.