Description
The detected position where the gun tip hits the welded target exceeded the allowable limit while executing correction operation in GUN TEACH POSITION CORRECT Mode.
Subcode description
Sub Code: Signifies the axis in
which the alarm occurred
Causes and remedies
| Cause | Remedy |
|---|---|
| Software (incorrect setting) | 1. Reset the alarm. 2. Check the following settings. • Gun axis home position • Pulse-to-stroke conversion in the gun condition file • Movable-side wear compensation value |
| External influence | 1. Check the workpiece offset relative to the taught position. 2. Check whether the movable-side electrode has come off. |
| Other | If the alarm occurs again after implementing the countermeasures, contact our service department and describe the circumstances when CMOS.BIN was saved (operating procedure, etc.). |