1716

Category: Alarm

Cause

Dynamic braking power overload

1. Braking resistor wiring incorrect or making poor contact;
2. When using the built-in resistor, the default jumper wire may have become disconnected;
3. Insufficient braking resistor capacity;
4. Excessive braking resistor resistance causes prolonged braking;
5. Input voltage exceeds specifications;
6. Braking resistor resistance, capacity, or thermal time constant set incorrectly;
7. Servo drive fault

Corrective action

1. Check whether the braking resistor wiring is normal;
2. Check whether the built-in resistor wiring is normal;
3. Increase the braking resistor capacity;
4. Reduce the braking resistor resistance;
5. Reduce the input voltage;
6. Set appropriate parameters according to specifications;
7. Replace the servo drive