[Cause]
PowerWaveErrorCode No.16 occurred. Power was lost during saving, so the welding equipment settings do not match the current configuration and the data could not be restored. This error may occur when the software in the welding machine is updated.
[Countermeasure]
Cycle the system power. If the problem persists, before performing any other operations (power-off or jogging) after this alarm occurs, use the abnormal-state recording function ("Abnormal State Record" in the auxiliary menu) to obtain an image backup and contact the service center. If that function cannot be used, record the conditions and operating steps up to the alarm, obtain an image backup, and contact the service center.