Description
In comparison to the position, where the gun tip hits the welded target, at the previous wear detection, the position during pressuring exceeded the allowable limit which had been set in "ALLOAWABLE TOUCH RANGE" in the GUN DETAIL SETTING file.
Subcode description
Causes and remedies
| Cause | Remedy |
|---|---|
| Software (incorrect setting) | Check the following settings. • Gun axis home position • Allowable contact detection range in the gun detail setting file • Pulse-to-stroke conversion in the gun condition file |
| Other | If the alarm occurs again after implementing the countermeasures, contact our service department and describe the circumstances when CMOS.BIN was saved (operating procedure, etc.). |