Description
In drive module arg, the hardware identity of the drive unit at unit position arg is different from the identity specified in the configuration. The installed drive unit hardware ID is arg and the configured drive unit ID is arg .
Consequences
No action can be taken until the fault is corrected. The system will go to "System Failure" state.
Possible causes
The drive unit type does not match the drive unit type specified in the installation key.
Recommended actions
- Verify that the drive unit is in the correct position, i.e. the Ethernet cable is connected correctly.
- Verify that the drive module key matches the installed hardware.
- Replace drive unit with the drive module specified in the drive unit key.