Description
The spot high speed function is enabled despite the invalid status of GUN ARM CONTROL function.
Subcode description
Sub Code: Signifies the control
group in which the alarm
occurred
Causes and remedies
| Cause | Remedy |
|---|---|
| Software (incorrect setting) | The high-speed spot welding function is enabled while gun axis ARM control is not configured. Set servo gun ARM control according to the following procedure. 1. Start in maintenance mode. 2. Set the security level to management mode. 3. Select System > Setup > Optional Functions > Gun Axis ARM Control. 4. Enter the inertia and frequency, then enable the function. 5. Turn the power off and back on. |
| Other | If the alarm occurs again after implementing the countermeasures, contact our service department and describe the circumstances when CMOS.BIN was saved (operating procedure, etc.). |