Description
Emergency stop signal of PP is unmatched.
Subcode description
Emergency stop signal of
programming pendant was
unmatched longer than a certain
time.
Causes and remedies
| Cause | Remedy |
|---|---|
| Cable (abnormal) | 1. Reset the alarm. 2. If the alarm recurs, check the following items. • Disconnect and reconnect the programming pendant connector and check for loose contacts. • CN203 connector of the ASF01 board. • Replace the programming pendant cable. |
| Programming pendant (abnormal) | 1. Reset the alarm. 2. If the alarm recurs, replace the programming pendant. |
| ASF01 board (abnormal) | 1. Reset the alarm. 2. If the alarm recurs, replace the ASF01 board. For a system with multiple ASF01 boards connected, replace the ASF01 board connected to SDCA01 board No. 1. |
| Fuse (abnormal) | [For painting controllers (explosion-proof programming pendant specification)] 1. Reset the alarm. 2. If the alarm recurs, replace fuses FU10 and FU11 inside the painting module. |
| Other | If the alarm occurs again after implementing the countermeasures, contact our service department and describe the circumstances when CMOS.BIN was saved (operating procedure, etc.). |