[Cause]
The spot program position correction function is enabled, and a TP program was executed (or restarted) in Correction execution mode. Correction mode searches the spot points and corrects the teaching. This is only a record message.
[Countermeasure]
This is an informational message. No countermeasure is required. To execute spot program position correction in diagnostic mode, enable diagnostic mode on the spot program position correction settings screen as follows. 1. If TP is disabled, set the execution mode in AUTO mode to Diagnostic. 2. If TP is enabled, set the execution mode in teach mode to Diagnostic. To execute normal spot welding instructions, disable spot program position correction. 1. If TP is disabled, turn the spot program position correction enable signal OFF. 2. If TP is enabled, disable spot program position correction on the test execution screen.