Description
An error occurred when weld line coord shift was in execution.
Subcode description
PREFLOW not executed
Causes and remedies
| Cause | Remedy |
|---|---|
| Software (incorrect setting) | 1. When executing seam-coordinate shifting, start execution from the job point 1 point(s) before the ARCON instruction. 2. When executing seam-coordinate shifting, teach the ARCON instruction in the same job as the seam-coordinate shift motion job (do not teach a ARCON instruction in a job targeted by a CALL instruction if that job has no taught arc-start point). When ARCON with no arc-start taught point is used in the destination of the CALL instruction, disable the weld line coordinate shift function in the arc start condition file. |
| Other | If the alarm occurs again after implementing the countermeasures, contact our service department and describe the circumstances when CMOS.BIN was saved (operating procedure, etc.). |