[Cause]
PowerWaveErrorCode No.363 occurred. The wire feed speed (WFS) is outside the production monitoring “Weld Curve” limits. The wire feed speed may be below the lower speed limit or above the upper speed limit.
[Countermeasure]
Check that the welding setting for wire feed speed is correct. Check that the wire feed speed limits for the weld curve are within an appropriate range for the application. This also includes “Seconds Until WFS Limit” (time until the WFS limit, in seconds) in the “General Settings” section. To exclude the start and end of welding, check that the start delay and end delay are set appropriately.