WARN Contact speed cannot be compensated because indentation amount %s[mm] has been reached

[Cause]

The minimum indentation amount required to compensate the contact speed during pressure application (automatically calculated) exceeds the maximum indentation amount (thickness plus pressure-side stroke limit). The minimum indentation amount (displayed value) has been clamped to the maximum indentation amount.

[Countermeasure]

Reduce $SGGUN.$SETUP.$PUSH_MARGIN or increase the pressure-side stroke limit. When this alarm occurs, contact speed is not compensated because sufficient deceleration distance for contact speed cannot be secured.
Note 1: This alarm generally indicates an incorrect pressure-side stroke limit. The stroke limit must be at least 5mm.
Note 2: In trial mode, thickness is automatically added to the indentation amount to compensate for the absence of a workpiece.