Description
An error occurred at form cutting operation.
Subcode description
Invalid radius setting.
- For a circle: radius <= 0, radius < minimum radius, or radius > maximum radius.
- For an ellipse: radius <= 0, radius < minimum radius / 2, or radius > (maximum radius / 2 - transverse distance / 2).
Causes and remedies
| Cause | Remedy |
|---|---|
| Software (incorrect setting) | Check the radius data settings. |
| Other | If the alarm occurs again after implementing the countermeasures, contact our service department and describe the circumstances when CMOS.BIN was saved (operating procedure, etc.). |