Description
An error was detected in the base block signal (motor current cutoff).
Subcode description
Sub Code: Signifies the axis in
which the alarm occurred
Causes and remedies
| Cause | Remedy |
|---|---|
| Cable (abnormal) | 1. Reset the alarm. 2. If the alarm recurs, check that the following cables and connectors are connected and fully inserted. • SDCA01 board-CN501 • Cable for ASF01 board-CN205 • Inverter board-CN571 |
| SDCA01 board (abnormal) | 1. Reset the alarm. 2. If the alarm recurs, replace the SDCA01 board. As a precaution, save CMOS.BIN before replacing the board. |
| ASF01 board (abnormal) | 1. Reset the alarm. 2. If the alarm recurs, replace the ASF01 board. As a precaution, save CMOS.BIN before replacing the board. |
| Other | If the alarm occurs again after implementing the countermeasures, contact our service department and describe the circumstances when CMOS.BIN was saved (operating procedure, etc.). |