Description
The procedure of the accessing to I/O module did not finish in the defined period.
Subcode description
The procedure of the accessing
to I/O module which is
connected with 1st PCI
connector did not finish in the
defined period.
Causes and remedies
| Cause | Remedy |
|---|---|
| Software (incorrect setting) | Check the following settings. • Maximum waiting time for contention between board processes when the SST-DN4 board is used. • PCI slot number in which each PCI board is installed • IO module setup in maintenance mode |
| Cable (abnormal) | 1. Turn the power off and back on. 2. If the alarm recurs, check that the following connectors are connected and fully inserted. • PCI connector of the corresponding IO module |
| IO module (abnormal) | 1. Turn the power off and back on. 2. If the alarm recurs, replace the following boards. As a precaution, save CMOS.BIN before replacing the board. • Corresponding IO module (PCI board) |
| AIF board (abnormal) | 1. Turn the power off and back on. 2. If the alarm recurs, replace the AIF01 board. As a precaution, save CMOS.BIN before replacing the board. After replacing the AIF01 board, load CMOS.BIN saved before the alarm occurred. |
| Other | If the alarm occurs again after implementing the countermeasures, contact our service department and describe the circumstances when CMOS.BIN was saved (operating procedure, etc.). |